11-13 May 2011
Design, Test, Integration
& Packaging of MEMS/MOEMS
Presentations | Hotel / Venue & Access | Contacts | Social event | Poster Information | Registration | Panels | Technical program | Conferences: | CAD, Design and Test Conference | Microfabrication, Integration and Packaging Conference | Invited Speakers Special Sessions Past events |
Posters will be mounted during the first break or during the lunch time. Please, make sure to remove all posters mounting material from the board at the end of the DTIP. Posters not removed in time will be taken down by the poster service staff. However, we can not assure any further responsibility for the material.
During the Poster session you will be given 3 minutes for the introduction of your poster in one slide, this slide must not be a view of the poster itself that would be unreadable by the audience. The detailed timing is given in the Program.
Your poster area can be 2m20 x 0m95 (height x width). Please display the title of your poster with 0m40 high printed capital letters at the top of the poster area. Your poster material should be attached on the surface with tape. Poster mounting materials will be available at the poster service desk. Do not use pins.Text layout
Give a short and comprehensive review of the basic items of your study. This can be done by dividing your text into several but clearly delineated paragraphs. Remember that it is easy to start reading a paragraph of six lines, but most people avoid one with 30! Please use letter-heights and figure sizes appropriate to read the poster from a distance of 1 m.Illustration layout
Drawings, diagrams and photos are extremely helpful and often necessary to display results and conclusions. Make sure that your illustrations are easy to understand - do not overload any chart or drawing with information.
We are looking forward to your poster presentation at DTIP.